I think the previous complaints were with the punch in, not punch out but i will look into it.
iirc the oldest firm for rev k/l is .94 which it looks like is not in the fw downloads sections at the moment, but i will post it tomorrow when i am at the office if you want to roll back.
Hey, yea it could be punch in. Didnt really notice which part of the loops were missing. I was instinctively trying to compensate on the release of the footswitch.
LudicrouSpeed wrote:Man, I've been loving the ct5 on this cruise. Helps me make weird sounds so much. One guest said he thought I had a "steel drum" effect on my guitar
Let me guess...
Mix at 50% or more
DIR 1 at unison forward
Len B at the shortest or second shortest setting
Feedback around 9:00 or so
This is my faux "steel drum" sound. At some points it can also sound like a banjo depending on where the mix and FBK are. Such a cool sound
multi_s wrote:
some people asked about how to add an additional jack for remote footswitches. this way you can tape teh pedal to your guitar/table but still use a footswitch to record etc. im not offering this mod really but i will post the info on how to do it, quite straightforward
Hey folks.
My apologies for the repost.
I'm still hoping to get some detailed info on the remote soft switch mod. Has anyone tried this? Sent a couple of emails to Scott but no response after a few weeks. I'm sure he's busy. About to head into the studio for a couple of weeks and it would be pretty great to get this happening.
JonnyAngle wrote:Cold not you just wire a jack to the switch and make a remote switch in a small box?
Basically, yeah? If it's just connected to the microcontroller and it's just a ground-switch signal, you can just use a mono cable and a simple normally-open switch
multi_s wrote:
some people asked about how to add an additional jack for remote footswitches. this way you can tape teh pedal to your guitar/table but still use a footswitch to record etc. im not offering this mod really but i will post the info on how to do it, quite straightforward
Hey folks.
My apologies for the repost.
I'm still hoping to get some detailed info on the remote soft switch mod. Has anyone tried this? Sent a couple of emails to Scott but no response after a few weeks. I'm sure he's busy. About to head into the studio for a couple of weeks and it would be pretty great to get this happening.
Hi,
Yes you can just put a normally open switch in parallel with the soft switch and connect it through a 1/4 in ch jack. there is room beside the current expression pedal jack inside the case to put a panel mount jack. If you have a rev k/l model the sleeve of teh ts jack you add should be connected to the same lug as the green wire on the soft switch and the tip to the lug with the black wire.
multi_s wrote:
Yes you can just put a normally open switch in parallel with the soft switch and connect it through a 1/4 in ch jack. there is room beside the current expression pedal jack inside the case to put a panel mount jack. If you have a rev k/l model the sleeve of teh ts jack you add should be connected to the same lug as the green wire on the soft switch and the tip to the lug with the black wire.
Did I miss the most recent Ct5 batch at the end of May, or has it just been delayed (no pun intended) a little bit? Just wanna make sure I've still got a shot at one!
njschneider2 wrote:Did I miss the most recent Ct5 batch at the end of May, or has it just been delayed (no pun intended) a little bit? Just wanna make sure I've still got a shot at one!
