I've also been thinking for a few years about creating a 3-4 level angled frame to hold multiple detachable pedalboards. Like a cross between Aclam or Monark pedalboards and the modular rack you've got incoming. Was thinking of using the aluminum framing from 80/20, and if I ever make further progress I'll start a thread in the DIY section. https://www.8020.net/Ruiner wrote:Incoming... though it's not for Mothers. I'm going to convert it into a table top setup for pedals
This thread over on MW may be of interest: https://www.muffwiggler.com/forum/viewt ... e9451713dd
If only to end up pointing to this company: http://www.autocet.cat/studio-rack-or-rack-route/
Please continue to post progress on your idea for the table top pedal setup!
