TAFM internal pots
Moderator: smallsnd/bigsnd
-
Derelict78
- IAMILFFAMOUS
- Posts: 4844
- Joined: Wed May 13, 2009 6:57 am
- Location: Cadillac, MI
TAFM internal pots
If I was to mount external pots for these what would you suggest?
aen wrote:Or I'll just use fuzz. Then Ill sound cool regardless.
Achtane wrote:Well, volcanoes are pretty fuckin' cool. Like I guess lava flows are doomy. Slow and still able to to melt your eardrums.
-
smallsnd/bigsnd
- IAMILFFAMOUS
- Posts: 3981
- Joined: Sat Nov 29, 2008 12:57 pm
Re: TAFM internal pots
20k-25k linear for the bias. it will go from thinner/smoother > thicker/raspier. you could use a 50k if that's all you have, but i wouldn't go bigger than that as your range will most likely start to get bunched up at one end of the pot.
personally, i wouldn't go for an external pot for the feedback trim - you won't get too much use from it. i've actually taken it out of the newest TAFM pcb and use a 10k fixed resistor instead. bias will stay, though, as it helps dial in the right sound.
personally, i wouldn't go for an external pot for the feedback trim - you won't get too much use from it. i've actually taken it out of the newest TAFM pcb and use a 10k fixed resistor instead. bias will stay, though, as it helps dial in the right sound.